Author information
- 1
- a UMR 5253, Equipe MACS, ICGM, University of Montpellier , Montpellier , France.
- 2
- b Department of Pharmacy , Nîmes University Hospital , Nimes , France.
- 3
- c Ecole Doctorale des Sciences et Technologie (EDST), Laboratoire de Valorisation des Ressources Naturelles et Produits de Santé (VRNPS), Université Libanaise , Beyrouth , Liban.
Abstract
OBJECTIVE:
This work evaluates the functionalities of different superdisintegrants (SD) for manufacturing orodispersible mini tablets(ODMT) by direct compression.
METHODS:
Twenty-three formulations varying in SD type, concentration, and lubricant were used to manufacture ODMT. The ODMT were then characterized for the following properties: friability, porosity, tensile strength, in vivo and in vitro disintegration time (DT).
RESULTS:
The results show that the presence, type, and concentration of SD did not influence friability, porosity, or tablet tensile strength. With regards to in vivo DT, only cross-linked poly (vinyl pyrrolidone) improved DT in all the tested formulations. Results also showed that when using microcrystalline cellulose (MCC) above 20% in the formulation, DT is longer. Cross-linked carboxymethyl cellulose accelerates DT when the MCC content is less than 20%. As for cross-linked carboxymethyl starch and calcium alginate showed no improvement on DT. Results for in vitro DT were all shorter than in vivo results and there was no correlation with the in vivo evaluation.
CONCLUSIONS:
This study shows that there is a need to develop better in vitro testing that precisely simulates in vivo conditions and that are adapted to ODMT. This standardization of the test methods for ODMTs must be accompanied by an improvement in the comprehension of SD mechanisms.
KEYWORDS:
Orodispersible mini tablet; disintegration time; mini tablet characterization; superdisintegrants; tabletability
- PMID:
- 28581832
- DOI:
- 10.1080/03639045.2017.1339081